"Adam Thompson, MCNE, MCSE" wrote:
>
> Penty Wenngren wrote:
> > pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
> > pchb0 at pci0 dev 0 function 0 vendor "Pequr Technology", unknown
> > product 0x9 rev 0x05
> > pchb1 at pci0 dev 0 function 1 vendor "Pequr Technology", unknown
> > product 0x9 rev 0x05
> [...]
> > pcib0 at pci0 dev 15 function 0 "Pequr Technology PCI" rev 0x4f
> > pchb2 at pci0 dev 17 function 0 vendor "Pequr Technology", unknown
> > product 0x9 rev 0x05
> > pchb3 at pci0 dev 17 function 1 vendor "Pequr Technology", unknown
> > product 0x9 rev 0x05
>
> The 64-bit PCI slots are on the far side of an unrecognized PCI bridge
> chipset. That chipset doesn't advertise itself as a PCI-PCI bridge but
> instead as a PCI-Host bridge.
>
> "pcib0" = First detected PCI Bus
> "pchb0" to "pchb3" = first through fourth detected PCI-Host bridges,
> which usually implies that there's supposed to be a PCI bus (pci*) on
> the other side. However, in the case of a pchb?, the chipset needs to
> be supported before the far-side pci bus can be detected.
>
> What you've got there is an PCI bus that's connected to the (presumably)
> Intel 440HX or whatever it is chipset - but notice on the "pci0" line,
> the "(no bios)" comment. That means that the kernel was unable to deal
> with the machine's BIOS32 entries.
>
> [OK - if I'm off in left field on any of the details, just correct me
> politely. I'm going from memory here.]
>
> Good luck. I can't believe this machine was RedHat-certified, since as
> far as I can tell, 6.1 doesn't support the Pequr chipset either.
>
It's odd, isn't it...
http://bugzilla.redhat.com/certification/cert-report.php3?mod_machine_id=278
--
Penty Wenngren // Graphium Norstedts Tryckeri AB
|